Roper Range stove fault codes
From Just Solve the File Format Problem
Revision as of 05:16, 21 April 2015 by VolodyA! V Anarhist (Talk | contribs)
2 digit codes
| Fault code | Description |
|---|---|
| F0 | Board failure |
| F1 | Board failure |
| F2 | Oven temperature is too high |
| F3 | Oven temperature sensor (RTD) open |
| F4 | Oven temperature sensor (RTD) shorted |
| F5 | Board failure |
| F7 | Function key stuck on ERC |
| F8 | Board failure |
| F9 | Oven door lock failure |
4 digit codes
| Fault code | Description |
|---|---|
| F1-E0 | EEPROM communication error |
| F1-E1 | EEPROM checksum error |
| F1-E2 | UL A/D error(s) |
| F1-E3 | Wiring harness cavity size does not match previously stored value |
| F1-E4 | Model ID error |
| F1-E5 | Calibration shifted |
| F1-E6 | Latch signal mismatch error |
| F1-E9 | Stack overflow |
| F2-E0 | Shorted keypad (also called touch pad) |
| F2-E1 | Keypad cable unplugged |
| F2-E5 | Cancel key drive line open |
| F2-E6 | Cancel key drive line open |
| F3-E0 | Oven temperature sensor (RTD) opened (upper oven, if double oven) |
| F3-E1 | Oven temperature sensor (RTD) shorted (upper oven, if double oven) |
| F3-E2 | Oven temperature is too high (Cook mode) |
| F3-E3 | Oven temperature is too high (Clean mode) |
| F3-E4 | Oven temperature sensor (RTD) opened (lower oven, if double oven) |
| F3-E5 | Oven temperature sensor (RTD) shorted (lower oven, if double oven) |
| F3-E6 | Warming drawer sensor open |
| F3-E7 | Warming drawer sensor shorted |
| F4-E1 | Meat probe malfunction - shorted |
| F5-E0 | Door switches do not agree (condition exists when door switch is closed indicating an open door, and latch switch is closed indicating a locked door) |
| F5-E1 | Self clean latch will not lock |
| F5-E2 | Latch during CLEAN error |
| F5-E5 | Self clean temperature not reached within 45 minutes. |
| F5-E6 | Door is open, but latch is locked |
| F5-E7 | Self clean latch will not unlock |
| F6-E0 | Return line not connected |
| F7-E1 | Common switch wire is defective |
